45
Canister Muffler Installation
1.
Gather the header and canister parts as shown:
1 - 50mm drop flex header (left)
1 - 50mm drop flex header (right)
2 - MTW-75K canisters (front exit)
2 - Teflon couplers
4 - clamps
2. If canister mufflers are to be used, gather the
pre cut balsa canister tunnel baffles and
included silicone tubing as shown below.
3.
Remove the landing gear cover as shown be-
low.
4.
Dry fit the front tunnel balsa floor baffle and
trim as necessary. Apply medium CA glue to
baffle and install.
Note:
If using standard mufflers, skip the
following steps and go to throttle servo
installation located on page 50 step #1
