23
10. Plug the servo wire into the female end of the
36” extension and secure the servo connectors
with safety wire, string, tape, or other method.
Ensure the connectors will not come apart
from vibration or light tension.
11.
Plug the servo into the receiver and turn on.
Ensure the servo is centered and the servo arm
is parallel to the elevator hinge line. Adjust the
length of the pushrod so that the elevator is in
the neutral position when the servo arm is
parallel to the elevator hinge line. A 1 1/2”
servo arm is recommended to achieve full
deflection of the elevator bevel. Ensure the
servo does not bind at center or either end
point at full deflection.
12.
Repeat all the above steps for the other stab.
9.
Align the left and right sides of the control
horns to the mounting holes and mount using
six wood screws as shown.
Carbon reinforcement tube installation
1. Gather
the
supplied
carbon tube for
reinforcing the elevator pushrods. Wrap
masking tape around carbon tube for marking
the cut location.