68
9. Trace the location of the exhaust stack exit
holes.
Note:
Removing the tape from the sides of the
template will allow the template to lay flat,
This will make marking the exhaust stack
locations
easier.
10.
Extend holes towards fuse former by drawing a
2 1/2” long hole. This will allow the cowling
to slip over the stacks. Allow a 1/4” clearance
around the outside edge of the exhaust stack
tubes.
11.
Cut out the exhaust stack holes in template.
12. Trial fit the template until the proper size holes
are achieved. Do not forget to account for the
curve at the bottom of the cowl.
