32
8. Attach a metal threaded RC link to each
threaded coupler. Attach the RC links to the
rudder servo arm and then attach the servo arm
to the aft rudder servo as shown.
Note:
You will want to use a 3” to 3 1/2” servo arm
9.
Plug the rudder servo Y harness into the rud-
der channel of the receiver and power up.
Turn on transmitter to center rudder servos.
10. Use 4-40 rod and 4-40 easy links to connect two
servos together.
Note
: Rudder coupler hardware is not supplied.
Shown below are only recommendations.
Coupling rudder servos is left to the builders
discretion.
11.
If 4-40 easy links are used be sure to use metal
clips on the bottom of the easy links.