AEQ
PHOENIX STRATOS
68
-
Enable DHCP: enables the activation or deactivation of the automatic configuration of
IP addresses, masks and gateways. There must be a DHCP server in the network the
unit is connected to in order to make this option work. When “Enable DHCP” is
validated, the following parameters will be filled automatically; when “Enable DHCP” is
not validated you will be able to change them manually.
-
IP Address: valid IP address associated with that interface.
-
Subnet mask: valid subnet mask associated with that interface.
-
Gateway IP: valid gateway or network gateway address associated with that interface.
-
DNS Server: IP address of the external addresses resolution server, valid in the
geographic zone where codec is placed, or internal server (inside the local network)
authorized to translate alphanumeric URL identifiers into IP addresses.
Once those parameters are configured, and after pressing the “Apply” button, a confirmation
window will appear. After confirming, the equipment reboots and the communication re-
establishes in approximately 15 seconds.
If you have any doubts, please consult your IT network technician or directly contact the AEQ or
authorized distributors’ technical support department.
4.9. RS-232 Ancillary (End-to-end data channel).
This option is available in “Configuration“
“Miscellaneous“.
PHOENIX STRATOS allows you to perform a bidirectional data transmission between units by
means of RS232 rear connector. This option may be useful in order to send files from one
location to another, or also to control remotely other units with RS232 serial interface. Ancillary
data travels through IP in a separate stream from the audio.
This option allows you to activate/deactivate that data transmission, associate it to channel 1 or
2 and select the binary rate. Binary rates of 1200, 2400, 4800, 9600, 19200 or 38400 bauds can
be selected (only 9600 bauds in case the selected channel is transmitted through an ISDN
connection).
