AEQ
PHOENIX STRATOS
81
o
SYNCHRONIZING (depending on the communication interface, this may be an
extremely brief status).
o
CONNECTED.
Detail of Phoenix STRATOS calling
•
Verify that the SYNC LED beneath the CALL button is lighted in green to indicate that
the communication has been successfully established.
•
Press the ON AIR button associated with that communications channel to enable audio
to be transmitted over that interface in full duplex mode.
•
Once the connection has been established with the remote end, confirm the presence
of transmitted and received audio by checking the VU meters on the Phoenix
STRATOS front panel.
o
If necessary, adjust the levels in AUDIO SETTINGS
CODEC CHANNEL1
SETTINGS (or CODEC CHANNEL2 SETTINGS) menu or in ANALOG AUDIO
SETTINGS menu, according to the desired signal type.
5.5.3.1. Finalizing an IP communication in DIRECT SIP mode.
•
To finalize the communication, simply press the CALL button associated with the
communications channel currently being used on the front panel of the unit.
5.5.3.2. Receiving and accepting an IP communication in DIRECT SIP mode.
If the IP interface of the codec is suitably configured and the automatic answering mode is OFF,
when a call is received:
•
The unit will emit an audible notification signal. This can be disabled in MENU SYSTEM
8-SETTINGS
BUZZER.
•
The red CALL button light corresponding to the communications channel that receives
the call will blink simultaneously to notify you.
•
The caller’s information will appear on the OLED screen:
o
The communications interface through which the call is being received.
o
The communications channel through which the call is being received. The
channels and interfaces are associated in MENU SYSTEM
6-CHANNELS
Chn1 or Chn2
INTERFACE.
o
The calling number identifier.
Detail of the Phoenix STRATOS receiving a call
•
To accept the call, press the contextual button ACCEPT_C1 (when the call is received
through communications channel 1) or ACCEPT_C2 (when the call is received through
communications channel 2).
You can also accept the call by pressing the CALL button associated with the
communications channel that is receiving the incoming call.
•
You can monitor the status of the call on the OLED screen:
o
CONNECTING (depending on the communication interface, this may be an
extremely brief status).
o
SYNCHRONIZING (depending on the communication interface, this may be an
extremely brief status).
