AEQ
PHOENIX STRATOS
102
7. CONTROL TERMINAL OVER WEB BROWSER.
The PHOENIX STRATOS includes a WebServer that enables you to execute numerous
functions remotely over the Ethernet interface included in the back panel of the unit; with the aid
of a standard web browser (compatibility is guaranteed with Internet Explorer running on
Microsoft Windows operating system).
7.1. Upgrading the equipment firmware.
The PHOENIX STRATOS is supplied from the factory with the latest firmware versions
available. However, firmware versions with new features may be released in the future, making
it necessary to upgrade the equipment to be able to make use of these new functionalities.
Because the upgrading process must be handled with caution, we recommend having it done
by an authorized distributor, or under the instructions of the AEQ Technical Assistance Service.
If questions or problems arise, consult the Technical Assistance Service via electronic mail
([email protected]).
IMPORTANT NOTE: If the MICRO (CPU) of the equipment is upgraded, part of its configuration
may be modified, specifically the part having to do with the MAC addresses, URIs, the SIP
Proxy Server Users and the associated Passwords. It is important to make a note of these
codec parameters before upgrading in order to reconfigure them afterwards.
The entire PHOENIX STRATOS firmware versions upgrading process is done through the IP
interface of the unit, with the aid of a standard web browser (compatibility is guaranteed with
Internet Explorer running on Microsoft Windows operating system). By default, user and
password is “aeq”.
IMPORTANT NOTE: the recommended order for upgrading is: MICRO (CPU), DSP, FPGA
followed by the ISDN communication module . The process is iterative.
To upgrade the firmware, you must follow the steps detailed below:
1. From MAIN STATUS
SYSTEM
8-SETTINGS
ETHERNET SETTINGS
ETHERNET CONFIG, check the IP address associated with the Ethernet interface.
2. Power down the PHOENIX STRATOS.
3. Connect PHOENIX STRATOS to the PC from which you are going to perform the
upgrading process using a crossed cable.
4. Power up the PHOENIX STRATOS.
5. Open the Internet Explorer web browser and, in the address bar, enter HTTP://<IP
address obtained in point 1>. Press ENTER and the main screen will be displayed.
