61
EKI-9500 Series User Manual
To add a new SNMP community group:
Click
System
>
Advanced Configuration
>
SNMP
>
Community
>
Add Commu-
nity Group
.
Figure 4.50 System > Advanced Configuration > SNMP > Community > Add
Community Group
The following table describes the items in the previous figure.
Trap Receiver v1/v2
Use the SNMP v1/v2 Trap Receivers page to configure settings for each SNMPv1 or
SNMPv2 management host that will receive notifications about traps generated by
the device. The SNMP management host is also known as the SNMP trap receiver.
To access this page, click
System
>
Advanced Configuration
>
SNMP
>
Trap
Receiver v1/v2
.
Figure 4.51 System > Advanced Configuration > SNMP > Trap Receiver v1/v2
The following table describes the items in the previous figure.
Item
Description
Community Name
Community name used in SNMPv1/v2 packets. This is configured in
the client and identifies the access the user may connect with.
Group Name
Identifies the Group associated with this Community entry.
IP Address
Specifies the IP address that can connect with this community.
Submit
Click
Submit
to save the values.
Cancel
Click
Cancel
to close the window.
Item
Description
Host IP Address
The IP address of the SNMP management host that will receive traps
generated by the device.
Community Name
The name of the SNMP community that includes the SNMP manage-
ment host and the SNMP agent on the device.
Notify Type
The type of SNMP notification to send the SNMP management host:
Inform: An SNMP message that notifies the host when a certain
event has occurred on the device. The message is acknowl-
edged by the SNMP management host. This type of notification
is not available for SNMPv1.
Trap: An SNMP message that notifies the host when a certain
event has occurred on the device. The message is not acknowl-
edged by the SNMP management host.
SNMP Version
The version of SNMP to use, which is either SNMPv1 or SNMPv2.
