Advantech EKI-9512-C0IDW10E, User Manual

Page: 196 / 326

177 EKI-9500 Series User Manual
Click Switching > Filters > MAC Filters > Add .
Figure 4.190 Switching > Filters > MAC Filters > Add
The following table describes the items in the previous figure.
4.4.7 GARP
4.4.7.1 Switch
Use the GARP Switch Configuration page to set the administrative mode for the fea-
tures that use the Generic Attribute Registration Protocol (GARP), including GARP
VLAN Registration Protocol (GVRP) and GARP Multicast Registration Protocol
Item Description
MAC Address The MAC address of the filter. The destination MAC address of an
Ethernet frame must match this value to be considered for the filter.
When adding or editing a filter, note that you cannot configure the fol-
lowing MAC addresses in this field:

00:00:00:00:00:00

01:80:C2:00:00:00 to 01:80:C2:00:00:10

01:80:C2:00:00:20 to 01:80:C2:00:00:2F

FF:FF:FF:FF:FF:FF
VLAN ID The VLAN ID associated with the filter. The VLAN ID is used with the
MAC address to fully identify the frames to filter.
Source Members The port(s) included in the inbound filter. If a frame with the MAC
address and VLAN ID combination specified in the filter is received on
a port in the Source Members list, it is forwarded to a port in the Desti-
nation Members list. If the frame that meets the filter criteria is received
on a port that is not in the Source Members list, it is dropped. To add
source ports to the filter, select one or more ports from the Available
Port List field (CTRL + click to select multiple ports). Then, use the
appropriate arrow icon to move the selected ports to the Source Mem-
bers field.
Destination Mem-
bers The port(s) included in the outbound filter. A frame with the MAC
address and VLAN ID combination specified in the filter is transmitted
only out of ports in the list. To add destination ports to the filter, select
one or more ports from the Available Port List field (CTRL + click to
select multiple ports). Then, use the appropriate arrow icon to add the
selected ports to the Source Members field.
Submit Click Submit to save the values.
Cancel Click Cancel to close the window.