189
EKI-9500 Series User Manual
4.4.10.2
Interface Configuration
Use the MLD Snooping Interface Configuration page to configure MLD snooping set-
tings on specific interfaces.
To access this page, click
Switching
>
MLD Snooping
>
Interface Configuration
.
Figure 4.205 Switching > MLD Snooping > Interface Configuration
The following table describes the items in the previous figure.
4.4.10.3
Source Specific Multicast
The MLD Snooping Source Specific Multicast page displays Source Specific Multi-
cast (SSM) information learned by snooping MLDv2 reports. MLDv2 includes support
for SSM, in which a receiver can request to receive multicast packets from one or
more specific source address or from all addresses except one or more specified
source addresses. If a host sends an MLDv2 report, the MLD snooping feature
records the information and adds an entry to the table on this page.
Refresh
Click
Refresh
to update the screen.
Cancel
Click
Cancel
to restore default value.
Item
Description
Item
Description
Interface
The interface associated with the rest of the data in the row. When
configuring MLD snooping settings, this field identifies each interface
that is being configured.
Admin Mode
The administrative mode of MLD snooping on the interface. MLD
snooping must be enabled globally and on an interface for the inter-
face to be able to snoop MLD packets to determine which segments
should receive multicast packets directed to the group address.
Group Membership
Interval
The number of seconds the interface should wait for a report for a par-
ticular group on the interface before the MLD snooping feature deletes
the interface from the group.
Max Response Time The number of seconds the interface should wait after sending a query
if it does not receive a report for a particular group. The specified value
should be less than the Group Membership Interval.
Multicast Router
Expiration Time
The number of seconds the interface should wait to receive a query
before it is removed from the list of interfaces with multicast routers
attached.
Fast Leave Admin
Mode
The administrative mode of Fast Leave on the interface. If Fast Leave
is enabled, the interface can be immediately removed from the Layer 2
forwarding table entry upon receiving an MLD leave message for a
multicast group without first sending out MAC-based general queries.
Refresh
Click
Refresh
to update the screen.
Edit
Click
Edit
to edit the selected entries.
