Adtech ADT-DK300A, Manufacturer'S Manual

Page: 20 / 172

BZ001M056A ADT ‐ DK300A/400A Engraving Machine
11
)
Note
The tool also can return to reference point according to program instruction, i.e. returning to reference point
automatically.
0
Caution:
Generally, the system will perform home operation after connecting the power supply. If the power fails while the
machine tool is moving, the system also will return to reference point when the power supply is connected again. Return
to Z axis to prevent tool and workpiece from colliding, and damaging tool, workpiece and clamp.
3.2 Continuous feeding manually
Press the keys on the operation panel or handwheel to move the tool along every axis.
The operation follows:
⑴
Press the mode switch key [ ] to select manual operation;
(2) Press composite keys [ ], [ ]; [ ], [ ]; [ ], [ ]; [ ],
[ ] in numbers area to move the tool along selected axis.
In manual mode, key can be used to switch the manual speed and rapid traverse speed. The
rapid traverse speed of every axis depends on General parameter 009 ‐ 012 (rapid traverse speed setting).
After switching to rapid traverse speed, the manual speed of the position interface will be highlighted, while
the actual speed of the position interface is sampled from the moving speed of current axis. This value can
truly reflect the moving speed of current axis (unit: mm/min);
)
Note:
Only single axis motion is available in manual mode.
3.3 Single step feeding
Single step mode is similar to manual mode, the operations are same, but only moves a specified pulse
increment every time press the key.