Adtech ADT-DK300A, Manufacturer'S Manual

Page: 119 / 172

BZ001M056A ADT ‐ DK300A/400A Engraving Machine
110
parameters, and the finally displayed number will be effective.
¾
This parameter requires restart to take effect; the corresponding
axis must be rotary and set to 360° display (P2.062~069);
045
X physial Assign Num (restart)
046
Y physial Assign Num (restart)
047
Z physial Assign Num (restart)
048
4 physial Assign Num (restart)
Range : 0~4
Unit : Pulse port sequence No.
Authority : Super Admin
Default :
Effective time : Restart
Note : In default mode, the actual number of every axis corresponds to the silk
screen number on the shell. If certain function axis is abnormal, you can
replace the axis through this function. For example, set P2.045 to 4,
P2.048 to 1, then, any operation to X axis will be the operation to A axis
encoder port on the shell.
0: no such axis
1~4: corresponding to 1# ‐ 4# axis
049 Spindle physial Assign Num (restart)
Range : 0~4
Unit : Pulse port sequence No.
Authority : Super Admin
Default :
Effective time : Restart
Note : It is set to 0 by default, indicating that the principal axis is in variable
frequency control mode, i.e. analog or gear position control mode. To
use servo principal axis, a coding port is required (servo principal axis
must be in position control mode); you can modify this parameter to
specify the function.
0: variable frequency principal axis adjusted by analog
1~4: corresponding to 1# ‐ 4# axis
Note: If a pulse port is specified as the function port of principal axis, the
pulse port should be removed from previously corresponding function
axis number, or else the system will assign to principal axis after
restarted and the original function axis will be invalid.