Adtech ADT-DK300A, Manufacturer'S Manual

Page: 97 / 172

BZ001M056A ADT ‐ DK300A/400A Engraving Machine
88
used for GOO instruction
About start speed, 1 ‐ 2 rotation motor speed is recommended for step
motor; as above, the machine tool moves 5mm when the motor rotates
one cycle, and the speed is 5 ‐ 10mm/sec (300 ‐ 600mm/min). For servo
motor, the start and stop shouldn’t have vibration. If this speed is too
high, it will cause vibration during motion, and the step motor will be out
of step. If the machine tool vibrates when starting and stopping, you can
reduce the acceleration.
The acceleration and start speed also affect manual speed, home speed,
etc.;
021
X Soft P(mm)
022
X Soft PosLimit ‐ (mm)
023
Y Soft P(mm)
024
Y Soft PosLimit ‐ (mm)
025
Z Soft P(mm)
026
Z Soft PosLimit ‐ (mm)
027
4 Soft P(mm)
028
4 Soft PosLimit ‐ (mm)
Range : ‐ 9999~9999
Unit : mm
Authority : Operation admin or higher
Default : Maximum positive/negative value
Effective time : Instant
Note : Generally, the machine tool has hard limit signal. In this case, software
limit isn’t required. Please set the positive limit to +9999.999, and
negative limit to ‐ 9999.999.
If hard limit switch isn’t installed, please use soft limit, which uses
machine tool coordinate system as the base point. Positive limit and
negative limit are subject to actual distance (unit: mm).
Since soft limit decelerates and stops at the limit point, it may exceed
the set distance, which depends on acceleration time and speed. Please
keep certain margin when setting this parameter.
029
Inp Speed(mm/min)
030
InpStartSpeed(mm/min)