Adtech ADT-DK300A, Manufacturer'S Manual

Page: 139 / 172

BZ001M056A ADT ‐ DK300A/400A Engraving Machine
130
Default : 0
Effective time : Instant
Note : These parameters are reserved for the system.
030 System spindle speed
Range : 1~24000
Unit : None
Authority : Operation admin or higher
Default : 100
Effective time : Instant
Note : Set spindle speed S value of the system. If the user program uses one
spindle for speed processing, set the desired spindle speed, and the
spindle code doesn’t need to be written in the program. If the program
has spindle code, the system will perform the programming speed and
save in parameters.
031
If close spindle while executing M30
Range : 0~1
Unit : None
Authority : Operation admin or higher
Default : 1
Effective time : Instant
Note : This parameter sets whether to automatically open and close the
spindle when the program automatically starts and ends. If set to 1, the
spindle automatically closes before started, and automatically stops
during operation; after started, the spindle automatically opens.
10.7. Port configuration (P6.)
001
Wheel0.1 ‐‐‐‐‐‐‐‐ Input wire No.
…
…
014
A Alarm ‐‐‐‐‐‐ Input wire No.
Range : 24~37
Unit : None
Authority : Super Admin
Default : The port table in the manual
Effective time : Instant
Note : Handheld box interface and servo alarm function pin definition;
Servo alarm input port, handheld box position, axis selection, start,
pause, and emergency stop input port can be configured. The default
handheld box testing port is XS7, and servo alarm detection port is
XS1~XS4.