182
Chapter 8 Troubleshooting
8.3
Web Operational Procedures
This section contains the following information:
Connecting to the Network using a LAN Interface
Screen Outlines
Main Screen in Normal Mode
Status Display of Replaceable Components
Information Message
Setting the Buzzer Sound Volume
8.3.1
Connecting to the Network using a LAN Interface
To use a LAN interface, follow these steps:
The connector for 10Base-T/100Base-TX is equipped with the controller. 10Base-
T/100Base-TX is selected automatically.
Connect the LAN cable with the LAN connector shown in Figure 8.1.
The following figure displays an interface board not added to the control unit.
LAN connector
Figure 8.1
LAN Connector Location
Input the address of the web browser.
Input the controller IP Address of the connected with the network. In the dual system
configuration, the status of the devices (both controllers) can be monitored from one
controller.
Summary of Contents for HDS WMS100
