142
Chapter 7 Configuring Storage on the Thunder 9530™ V Series Subsystem
7.7
Applying Configuration Data to Another WMS100 Subsystem
This section includes the following:
System Parameters
RAID Group/Logical Unit
Port/Host Group
7.7.1
System Parameters
Set the system parameters in the array unit with the information described in the file. If you
set the system parameters using a file that was output when a priced optional feature is in
an unlocked state, the setting may terminate abnormally. To set system parameters, use a
file that was output when all priced optional features are in a locked state.
For a dual system, the setting cannot be executed if one of the controllers is detached.
Confirm that the array unit is operating normally.
While the system parameters are being set, the array unit cannot execute commands from
the host. The functions of Storage Navigator Modular can no longer work with the exception
of the Wizard for setting the system parameters and failure monitoring. After setting,
restart the array unit. Confirm that it is operating successfully, and then connect to the host
and the Storage Navigator Modular management program.
Note:
If the system parameter setting operation is performed for the array unit connected to
the NAS unit, the cluster between the NAS Units stops. When the system parameter setting
operation for the array subsystem is unavoidably performed, execute it after stopping the
cluster between the NAS Units and stopping the NAS OS of both NAS Units. Start the cluster
between the NAS Units again after completing the system parameter setting operation.
1.
Edit the file for which you will set system parameters to set the array unit. This file has
a specified format. The format of the file is the same as that of the file output by the
array unit. To format a file, refer to the file output in section 7.6.
2.
From the Tools menu, select Configuration Settings or click Configuration Settings on
the toolbar.
3.
Click the Constitute tab.
4.
Select the Input radio button in the Operation box.
5.
Select the System Parameter radio button in the Select Configuration Information box.
6.
Click Browse, and then specify the directory and file name of the file that describes the
system parameters edited in 1. The specified file name displays in the text box.
7.
Click Apply.
Note:
To validate the set system parameters, restart the array unit. The previous settings
stay valid until restarting. The array unit cannot access the host until the reboot is
completed and the system restarts. Therefore, be certain the host has stopped accessing
data before beginning the restart process.
Summary of Contents for HDS WMS100
