135
Static Resource Conflict
Two or more Static Devices are trying to
use the same resource space (usually
Memory or I/O).
PCI I/O conflict
PCI ROM conflict
PCI IRQ conflict
An I/O resource conflict was detected.
PCI IRQ routing table error
Unable to route an IRQ to the PCI device.
Timer Error
An error occurred while programming the
count register of channel 2 of the 8254
timer.
Interrupt Controller-1 error
The Master Interrupt Controller could not
be initialized.
Interrupt Controller-2 error
The Slave Interrupt Controller could not
be initialized.
CMOS BIOS message
CMOS Date/Time Not Set
The date and/or time values stored in the
CMOS are invalid. Run Setup to set correct
values.
CMOS Battery Low
The battery maybe losing power. Replace
the battery soon.
CMOS Settings Wrong
CMOS values are not the same as the last
boot. These values have either been
corrupted or the battery has failed.
CMOS Checksum Bad
The CMOS checksum is incorrect. CMOS
memory may have been corrupted. Run
Setup to reset values.
USB BIOS error messages
Warning! Unsupported USB
device found and disabled!
A non-bootable USB device is enumerated
and disabled.
Warning! Port 60h/64h
emulation is not supported by
this USB Host Controller!
The port 60h/64h emulation mode cannot
be enabled for this USB host controller.
Error message
Description
Summary of Contents for Altos G530 Series
