26
CAL BLEND REGULATOR ASSY
CAL BLEND CYLINDER
WORM GEAR CLAMP
NGC8200
RIGHT SIDE CUT-AWAY VIEW
Figure 32 Calibration Bottle Location
XV.
Calibration Gas Regulator Installation
The following instructions are valid for all installations.
NOTE:
DO NOT connect low pressure switch directly to the NGC.
A. Materials
•
Calibration Blend Regulator Assembly (see Figure 33)
•
Installed Calibration Gas Bottle
These instructions assume that the Carrier Gas bottle has previously been installed.
B. Instructions
1)
Remove protective cap from High Pressure Inlet if required.
2)
Insert Ferrule on Regulator High Pressure Inlet into Calibration Gas Bottle
Outlet.
3)
Screw Nut onto thread and tighten.
4)
Check for leaks.