5
Figure 5 CWE Mounting Hardware
IV.
Pipe Mounted Cold Weather Enclosure Mounting Kit
If your installation includes a Pipe Mounted Cold Weather Enclosure, follow these
instructions as well as the Optional Support Leg instructions if applicable, otherwise
continue to the next applicable set of instructions.
A. Materials
•
4 ea. ½” -13 x 1 ¼ SST Bolt
•
4 ea. ½” SST Flat Washer
•
4 ea. ½” SST Split Washer
•
2 ea. 2 ½” x ¼” 43” Steel Angle Iron
NOTE:
May be used in conjunction with optional Support Leg Kit. See Support
Leg installation procedures next in this chapter.
B. Installation
1)
Set two pieces of angle iron (see Figure 6) on bottom of upside down
enclosure, being sure the side with the holes is facing the bottom of the
enclosure and the solid sides of the angle iron are facing each other. Angle
iron should be spaced so that the diameter of the pipe will fit in between.
2)
Place a split washer, then a flat washer on one of the 1 ¼” Bolts (see Figure
7).
3)
Insert the Bolt through one of the slotted holes located in the angle iron into
the outermost corner of the enclosure. Move channel Nut into position so that
Bolt will screw into Nut.
4)
Screw Bolt into Nut, but leave loose for later adjustment.
5)
Install other Bolt, split washer and flat washer into other slotted hole.
6)
Repeat for other angle iron. Final tightening of Bolts is done after unit is
mounted on pipe to allow for left to right and front to back positioning.
