ABB i-bus KNX FCL/S 1.6.1.1, Product Manual

Page: 50 / 104

ABB i-bus
®
KNX
Start-up
48 2CDC508116D0203 | FCL/S x.6.1.1
Enable communication object
"Status Fan On/Off" 1 bit
Options: No
Yes
This parameter enables the communication object Status Fan ON/OFF .
Some fans initially need an ON telegram before they are set to a fan speed from the OFF state. This ON
telegram has effect on a main switch which has to be switched on. This requirement can be implemented
with any switch output controlled via the
Status Fan communication object. The corresponding switch
communication object of the switch actuator should be connected with the Status Fan communication ob-
ject.
With the option Yes , the following parameters appear:
Send object value
Options: No, update only
Only after changing
After request
After a change or request

No, update only : The status is updated but not sent.

Only after changing : The status is sent after a change.

After request : The status is sent after a request.

After a change or request : The status is sent after a change or a request.
The following parameter is only visible if the Enable automatic operation parameter in the Fan parameter
window is set to Yes .
Enable communication object
"Status Automatic" 1 bit
Options: No
Yes
This parameter enables the communication object Status Automatic .
Telegram value 1 = automatic operation active
0 = automatic operation inactive

Yes : The following parameter appears:
Send object values
Options: No, update only
Only after changing
After request
After a change or request

No, update only : The status is updated but not sent.

Only after changing : The status is sent after a change.

After request : The status is sent after a request.

After a change or request : The status is sent after a change or a request.