ABB i-bus KNX FCL/S 1.6.1.1, Product Manual

Page: 65 / 104

ABB i-bus
®
KNX
Start-up
FCL/S x.6.1.1 | 2CDC508116D0203 63
3.3 Communication objects
Note
As standard, the write flag (with the exception of 1 bit communication objects) is deleted with the com-
munication object values. Thus the communication object value cannot be changed via the bus. If this
function is required, the write flag must be set in ETS.
The communication object value is overwritten with the parameterized value after bus voltage recovery.
3.3.1 Summary of communication objects
CO No. Function Name
Data Point
Type (DPT)
Length
Flags
C R W T A
0 In Operation System 1,002 1 bit x x
1 Request status values General 1,017 1 bit x x
2…9
Not assigned
10 Fan speed switch Fan A 5,010 1 byte x x
11
Switch speed 1 Fan A (Multi-level) 1,001 1 bit x x
Switch Fan A (One-level) 1,001 1 bit x x
12 Switch speed 2 Fan A (Multi-level) 1,001 1 bit x x
13 Switch speed 3 Fan A (Multi-level) 1,001 1 bit x x
14 Fan speed up/down Fan A (Multi-level) 1,007 1 bit x x
15 Status fan ON/OFF Fan A 1,001 1 bit x x
16 Status Fan speed Fan A (Multi-level) 5,010 1 byte x x x
17 Status Fan speed 1 Fan A (Multi-level) 1,001 1 bit x x x
18 Status Fan speed 2 Fan A (Multi-level) 1,001 1 bit x x x
19 Status Fan speed 3 Fan A (Multi-level) 1,001 1 bit x x x
20 Run-on Fan A (Multi-level) 1,003 1 bit x x
21 Limitation 1 Fan A 1,003 1 bit x x
22 Limitation 2 Fan A 1,003 1 bit x x
23 Limitation 3 Fan A 1,003 1 bit x x
24 Limitation 4 Fan A 1,003 1 bit x x
25 Forced operation Fan A 1,003 1 bit x x
26 Automatic On/Off Fan A 1,003 1 bit x x
27 Status Automatic Fan A 1,003 1 bit x x x
28 Status Byte mode Fan A non DPT 1 byte x x x
29
Control value A Fan A (2 control values) 5,010 1 byte x x
Control value Fan A (only 1 control value) 5,010 1 byte x x
30 Control value B Fan A (2 control values) 5,010 1 byte x x
31 Toggle control value A/B Fan A (2 control values) 1,001 1 bit x x
32 Fault control value Fan A 1,005 1 bit x x x
33…39
Not assigned