ABB FSCA-01, User Manual

Page: 64 / 90

64 Communication profiles
7 ALARM 1 Warning/Alarm
0 No warning/alarm
8 AT_
SETPOINT 1 OPERATION. Actual value equals reference
(= is within tolerance limits, ie, in speed
control, speed error is 10% max. of nominal
motor speed).
0 Actual value differs from reference (= is
outside tolerance limits.)
9 REMOTE 1 Drive control location: REMOTE (EXT1 or
EXT2)
0 Drive control location: LOCAL
10 ABOVE_
LIMIT 1 Actual frequency or speed equals or exceeds
supervision limit (set by drive parameter).
Valid in both directions of rotation.
0 Actual frequency or speed within supervision
limit
11 EXT_CTRL_
LOC 1 External Control Location EXT2 selected.
Note concerning ACS880 and ACS860:
This bit is effective only if the fieldbus
interface is set as the target for this signal by
drive parameters. User bit 0 selection
(06.33).
0 External Control Location EXT1 selected
12 EXT_RUN_
ENABLE 1 External Run Enable signal received.
Note concerning ACS880 and ACS860:
This bit is effective only if the fieldbus
interface is set as the target for this signal by
drive parameters. User bit 1 selection
(06.34).
0 No External Run Enable signal received
13…
14
Drive-specific (For information, see the drive documentation.)
15 FBA_ERROR 1 Communication error detected by fieldbus
adapter module
0 Fieldbus adapter communication OK
Bit Name Value STATE/Description