ABB ACQ810-04, Hardware Manual, Page: 67 / 144

Installation 67
Safety
WARNING! Only qualified electricians are allowed to carry out the
electrical installation work described in this chapter. Follow the Safety
instructions on the first pages of this manual. Ignoring the safety
instructions can cause injury or death.
Checking the installation site
The material below the drive must be non-flammable and strong enough to carry the
weight of the drive.
See section Ambient conditions on page 124 for the allowed ambient conditions and
section Losses, cooling data and noise on page 121 for the required cooling air.
Required tools
•
Set of screw drivers (Torx and Pozidrive)
•
Torque wrench with a 500 mm (20 in.) or 2 × 250 mm (2 × 10 in.) long extension bar
•
17 mm (11/16 in.) magnetic-end socket for mounting the drive module busbars to the
optional cabling panels (+H381)
•
10 mm magnetic-end socket or a Torx screw driver for mounting the drive module top
fastening bracket to the cabinet back and for mounting the optional cabling panels
(+H381) to the cabinet side panels
•
13 mm socket for mounting the drive module to the cabinet bottom plate or floor
•
22 mm magnetic-end socket for mounting the cable lugs to the terminals (M12 bolt).
Moving and unpacking the unit
WARNING! Follow the safety instructions, page 11 . Ignoring the instructions can
cause physical injury or death, or damage to the equipment.
Move the transport package by pallet truck to the installation site.
Unpack the package as follows:
•
Cut the bands (A).
•
Unpack the additional boxes (B).
•
Remove the outer sheathing by lifting it (C).
•
Remove the sheathing by lifting it (D).
•
Insert lifting hooks to the drive module lifting eyes and lift the module to the installation
place.