3D-ONE CP31, Operating Instructions Manual, Page: 24 / 53

Ov
erview
16.
External indications
1.
REC
100907-102725
00:04:51
103 GB free
Play Mode
To enable PLAY mode you have to press
the PLAY button so that it turns green.
The camera will then be set into PLAY
mode, which takes several seconds
during which a purple screen is shown
on the VIEWFINDER.
The camera will then automatically start
playing the last recorded file and show
the filename on the TOUCHSCREEN. To
swap to a previous recording press the
PLAY PREV button, to skip forward press
the PLAY NEXT button.
To exit PLAY mode and return to LIVE
mode, press the PLAY button again. It
will then take several seconds for the
camera to return to LIVE mode.
Play
1009-121327
<< >>
PLAY
PLAY NEXT PLAY PREV
External
indications
RECORD Tally light
When the camera is recording mode,
both REC buttons will light red and on
the front of the camera a tally light will
be lit.
AUDIO +48V Volt
indicator
The +48V indicator light indicate that on
the corresponding XLR 48V are
provided by the camera to the output.
WARNING
Activating the +48V output can seriously
damage equipment that is plugged into
the XLR connector, if the equipment can
not 48V.
AUDIO peak indicator
The AUDIO PEAK indicator lights light up
if the audio input will be clipped by the
camera. Reduce the gain if required.
POWER indicator
The blue POWER indicator will light two
seconds after the POWER button has
been pressed, indicating the successful
power up of the camera.
NOTE
After powering on the camera it will
take approximately 30 seconds to boot
completely. While the camera is starting
up the TOUCHSCREEN is showing the
message