3D-ONE CP31, Operating Instructions Manual, Page: 22 / 53

Ov
erview
14.
Touchscreen indications and operation
1.
[Picture] Gamma
The gamma curve applied to both
sensors can be adjusted using the slider
labelled GAMMA. Typically 1.8 is used.
[Picture] Compression
The compression applied to the stored
videos can be adjusted using the slider
labelled COMPRESSION. Typically ‘WEAK’
is used.
[Network] DHCP client/server
You can switch the camcorder between
DHCP SERVER and CLIENT mode using
the DHCP SERVER button. In CLIENT
mode the camera will wait for an
external server to assign an IP address
to the camera. IN SERVER mode the
camera will hand out IP addresses to
connected equipment, in the range of
192.168.100.20 - 192.168.100.254.
[Network] IP address
The IP address of the camcorder will be
displayed in the field IP ADDRESS on the
TOUCHSCREEN. If ‘-‘ is shown, then either
no network cable is connected or no IP
address has been (yet) assigned.
[HDMI] HDMI
The HDMI button enables/disables the
external HDMI output at full resolution.
If the HDMI button is disabled (white)
then the VIEWFINDER is active and the
HDMI outputs provide a 852x600 signal,
identical to the VIEWFINDER.
When the HDMI button is enabled
(green) then the HDMI output provides
the same resolution as set on the sensor
(see Resolution page 13) and the
VIEWFINDER is blackened.
The HDMI output frequency depends on
the chosen frame rate (24/25/30/50/60
fps) and the corresponding setting HDMI
output frequency setting (see below).
HDMI << >>
HDMI
HDMI freq normal
HDMI OSD
[HDMI] HDMI freq double/freq
normal
This HDMI freq double/normal button
switches between a HDMI output
frequency that is identical to the sensor
frequency (‘normal’) or one that is
doubled.
[HDMI] OSD
The HDMI OSD button turns OSD display
on/off on the HDMI outputs and on the
internal viewfinder.
[Zebra] Zebra OLED
The Zebra OLED button turns zebra
pattern display on/off on the
VIEWFINDER. Single hatched lines are
shown at 70% intensity levels, crossed
hatched lines at 99% intensity levels.
Zebra << >>
Zebra OLED Zebra HDMI
Zebra Y
[Zebra] Zebra HDMI
The Zebra HDMI button turns zebra
pattern display on/off on the HDMI
outputs. Single hatched lines are shown
at 70% intensity levels, crossed hatched
lines at 99% intensity levels.