3Com VCX V7000, Installation Manual

Page: 354 / 488

352 A
PPENDIX
B: A
UTOMATED
B
RANCH
O
FFICE
I
NSTALLATION
Sample V6000 Media Gateway Configuration File (continued)
SNMPManagerTableIP_1 = 0.0.0.0
SNMPManagerTableIP_2 = 0.0.0.0
SNMPManagerTableIP_3 = 0.0.0.0
SNMPManagerTableIP_4 = 0.0.0.0
SNMPTrapManagerHostName = ''
One of the five available SNMP managers can be defined using a Fully
Qualified Domain Name.The gateway tries to resolve the host name at
start up. Once the name is resolved (IP is found), the resolved IP address
replaces the last entry in the trap manager table (defined by the
parameter ‘SNMPManagerTableIP_x’) and the last trap manager entry of
snmpTargetAddrTable in the snmpTargetMIB. The port is 162 (unless
specified otherwise), the row is marked as ‘used’ and the sending is
‘enabled’.
SyslogServerIP = 10.230.64.57
Enter the IP address of the VCX server that is located in the same chassis
as the Media Gateway. The default port is 514.
EnableSyslog = 1
Set this value to 1 to enable the Media Gateway to send system log
information and error messages to the log server. Typically, system log
information is used only for troubleshooting purposes.
EnableLANWatchdog = 1
Set this value to 1 to enable the Media Gateway to restart when a LAN
failure is detected.
DHCPEnable = 1
When the Media Gateway starts, it first attempts to contact a BOOTP
server. If no BOOTP server responds and if DHCPEnable is set to 1, the
gateway attempts to obtain an IP address from a DHCP server.
[Analog Params]
LifeLineType = 2
Set this parameter to 2 to activate the lifeline under any of these
conditions:
■
The media gateway loses power
■
The network link is physically disconnected
■
The network link fails for any reason