3Com VCX V7000, Installation Manual

Page: 380 / 488

378 A
PPENDIX
B: A
UTOMATED
B
RANCH
O
FFICE
I
NSTALLATION
Sample V6100 Media Gateway Configuration File
PROXYREDUNDANCYMODE = 1
Enable (1) or disable (0) the gateway to always try to work with the
primary Proxy. If this parameter is set to 0 and the primary proxy fails, the
gateway continues to work with the last active proxy until a proxy failure
occurs.
ALTROUTINGTEL2IPENABLE = 1
Alternate routing of calls is possible if the initial destination cannot be
pinged or if poor quality of service (QoS) is detected. Possible values are:
■
0 — Disable alternate routing.
■
1 — Enable alternate routing
■
2 — Provide read-only information on the quality of service of the
destination IP address. Alternate routing is disabled.
ALTROUTINGTEL2IPMODE = 3
If alternate routing is enabled, select an alternate routing mode. Possible
values are:
■
0 — Alternate routing is not used.
■
1 — Alternate routing is performed if a ping to the initial destination
fails.
■
2 — Alternative routing is performed if a poor quality of service is
detected.
■
3 — Alternative routing is performed if either a ping failed or poor
quality of service was detected.
GWAPPDELAYTIME = 5
Specify, in seconds, the amount of time that the gateway’s operation is
delayed after a reset cycle. The default value is 0 (zero).
NOTE: Increasing
the delay can overcome connection problems caused by some LAN
routers.
DISCONNECTONBROKENCONNECTION = 0
Enable (1) or disable (0) the disconnection of a call if RTP packets are not
received for a defined time period (see BrokenConnectionEventTimeout).
The default timeout value is 10 seconds. This feature cannot be used if
silence compression is enabled.