Zodiac AquaLink M8, Руководство по установке

Страница: 25 / 44

Page 25
AquaLink
®
M8 | Installation Manual
Page 24
AquaLink
®
M8 | Installation Manual
5. Feed the four conductor wire into the Power Center
through the low voltage raceway.
6. Cut off the excess wire. Strip the jacket back 6”
and strip the individual wires approximately ¼”.
Connect the four conductor wire to the red terminal
bar on the Power Center PCB.
7. Install the dead panel to the Power Center and
restore all power.
Conduit Knockout for Low Voltage Wires
Low Voltage
Raceway
High Voltage
Knockouts for
Conduit
(DO NOT run any Low
Voltage wires through
these knockouts)
Figure 29. AquaLink J-Box Cable Connection to
Power Center PCB
Low
Voltage
Raceway
6’ Min.
To
Ground
Level
Blower or
Other Equipment
Low
Voltage
Cable
High Voltage
Raceway
Transceiver
J-Box
8’ Min.
18-Channel RF Transceiver
“A”
3
Yellow
1 Red 2 Black 4 Green
1/4”
6”
DETAIL “A”
Figure 30. Outdoor Transceiver J-box Installation
4.5.2 AquaLink Handheld Remote
Installation
1. Remove the Handheld Remote from the packaging.
2. On the back of the Handheld Remote, loosen and
remove the two (2) screws that secure the cover for
the battery chamber (see Figure 31).
3. Install two (2) AA batteries. Ensure that the
polarity is correct.
4. Re-install the cover for the battery chamber and
secure with the two (2) screws removed in Step 2.
Two (2) AA Batteries
Battery
Enclosure
Handheld Remote
Back View
Cover
UM-3/R6/AA
UM-3/R6/AA
BATTERY
1.5V x 2
Figure 31. Battery Installation on Handheld Remote