Zodiac AquaLink M8, Руководство по установке

Страница: 17 / 44

Page 17
AquaLink
®
M8 | Installation Manual
Page 16
AquaLink
®
M8 | Installation Manual
the shaft to stop again. If the stop positions are not
correct, reset the cams until correct.
NOTE: If the actuator does not move in either direction,
refer to Section 6, Troubleshooting .
10. Replace the lid and tighten screws. Replace the handle
and locking knob.
NOTE: The end of the handle which has the word OFF
embossed on it exactly duplicates the shape of
the valve diverter. When the handle is placed on
a valve or actuator shaft the word OFF will be
directly over the center of the valve diverter.
3.6 OneTouch
™
Control Panel
Installation
3.6.1 Surface Mount OneTouch Installation
1. With the aid of the homeowner, find the best
location for the control panel.
2. Place surface mount box in the location chosen for
the control panel. Mark the holes for drilling. Drill
5mm holes for the sheet rock anchors and a 45mm
hole for the 4-conductor cable.
3. Run the 4-conductor cable from the power center
to the location of the control panel (see Figure 10).
Sheetrock
Surface
Mount Box
OneTouch
PCB
Faceplate
Figure 22. OneTouch™ Surface Mount Installation
4. Pull the 4-conductor cable through the hole in the
wall and the hole in the surface mount box. Mount
the box to the wall using the screws provided.
5. Wire the 4-conductor cable to the red, 4-pin
terminal bar (see Figure 23). Push the 4-pin
terminal bar onto the back of the OneTouch PCB.
Place the PCB with LCD and buttons back into the
box. Insert the screws and hand tighten.
Do not
overtighten. Snap the faceplate into place.
W2
W1
4 3 2
1
Green
Yellow
Black
Red
Figure 23. OneTouch PCB - Back View
Cam Setting Chart
NOTE
: Before resetting cams, always rotate the actuator shaft so the arrow aligns with the pointer above its microswitch.
Actuator
Mounting
Water Enters Port
Common Port
Cam Setting
Top Cam Bottom Cam
Water Exits Valve
Port or Port
*I A 90 180 B C
I B 90 270 A C
I C 180 90 A B
*II A 180 90 B C
II B 0 0 A C
II C 90 180 A B
*III A 90 180 B C
III B 270 90 A C
III C 0 270 A B
*IV A 0 270 B C
IV B 180 180 A C
IV C 270 0 A B
*Two Port Valve Settings