Zodiac AquaLink M8, Руководство по установке

Страница: 24 / 44

Page 25
AquaLink
®
M8 | Installation Manual
Page 24
AquaLink
®
M8 | Installation Manual
4.4 OneTouch
TM
System Defaults
and General Modes
Default Temperature (Pool/Spa Combination)
Default Pool Temp = 80°F
Default Spa Temp = 102°F
Default Temperature (Pool/Spa Only)
Default TEMP1 = 80°F
Default TEMP2 = 60°F
Default Spa Side Switch Settings
Button 1 = Spa (Filter Pump for pool/spa only models)
Button 2 = Spa Heater (Temp1 for pool/spa only mod-
els)
Button 3 = AUX1
Button 4 = AUX2
Default Freeze Protection Settings
FILTER PUMP: freeze protection ON. ALL OTHER
EQUIPMENT, freeze protection OFF.
NOTE If you select SPA to be freeze protected, water
circulation will switch between pool and spa
every 30 minutes during freezing conditions
once freeze mode is active.
4.4.1 Power Center Service Switch
AUTO Mode (automatic)
1. The control panel has complete control of all
functions.
2. All programmed settings will operate.
3. All safety delays and equipment protection
interlocks are operational.
SERVICE Mode
1. The power center has complete control of all
functions.
2. Service mode must be turned on/off at the power
center.
3. No programmed settings will work.
CAUTION
In service mode, the safety interlocks for equipment
protection are overridden.
TIMEOUT Mode
1. The power center has complete control for three (3)
hours.
2. After three (3) hours the system will return to
AUTO mode.
3. Programmed on/off times will be overridden during
the three (3) hours.
4. After the three (3) hour “time out”, the system
will resume any programmed items that were
overridden.
4.4.2 Power Interruption
In the event there is a power interruption, and the
AquaLink M8 system is in service or time Out mode,
the system will default to auto. In previous firmware
versions, the system would default to last mode of
operation.
ATTENTION
Special Note to Startup Person: The AquaLink
M8 allows two (2) options for operating the pool
equipment on the first day of operation:
Option #1 Once all programming of equipment
is completed, the AquaLink
®
RS will
automatically review all programs
and turn on any equipment which is
programmed to be on.
Option #2 To operate the filter pump or cleaner
continually for the first day, leave the
power center service button in AUTO
mode. At the indoor control panel,
press the filter pump or cleaner buttons
for the equipment you want to run.
The equipment that is activated will
run continuously, ignoring the first
programmed off time, and will turn off at
the programmed off time for the next day
(only if a program has been entered).
4.5 PDA Installation
4.5.1 AquaLink Transceiver J-box
Installation
Installation Considerations. The remote will transmit
through walls and around corners. Steel framing,
aluminum siding, wrought iron, cyclone fences,
leaded glass, and other 900 MHz frequency items may
inhibit/prevent communication between the AquaLink
Handheld Remote and the transceiver. The system does
not require line of sight to communicate. To optimize
communication, it may be helpful to try multiple
transceiver locations before permanantly mounting it to
a location that maximizes its range.
1. Turn off all power to the Power Center.
2. When practical to do so, mount the Outdoor
Transceiver J-box at least 6’ above the ground and
at least 8’ from any air blowers that may be in the
vicinity.
3. The Transceiver J-box antenna must point towards
the sky.
4. Open the door to the Power Center and remove the
dead panel.