Zodiac AquaLink M8, Руководство по установке

Страница: 26 / 44

Page 27
AquaLink
®
M8 | Installation Manual
Page 26
AquaLink
®
M8 | Installation Manual
4.5.3 Changing the Frequency Channel
If your AquaLink RS system is turning items on or
off at undesignated times, another AquaLink RS
Handheld Remote system may be in close proximity
using the same or similar frequency channel. To prevent
unwanted operation the channel for your AquaLink
RS system can be changed. The AquaLink Handheld
Remote and the AquaLink Transceiver J-box must be
set to the same RF channel .
MAIN CONNECTOR
RESET
D2
D3
LEARN
Y B R G
OFF
ON
Red LED
(Send)
PCB
Transceiver J-Box
Internal View
Green LED
(Receive)
Reset
Button
Learn
Switch
Figure 32. AquaLink Transceiver J-Box - Internal
View
1. At the Transceiver J-box, remove the cover to
expose the PCB (see Figure 20).
2. On the AquaLink Handheld Remote, press
and hold both the UP and DOWN arrows
simultaneously for three (3) seconds. After 3
seconds, the CHANNEL SETUP screen appears.
Select a channel.
3. Use the UP and DOWN buttons to highlight the
desired RF channel. Then press SELECT.
4. When the RF channel is selected, the following
message appears on the Handheld Remote display
screen:
Set slide switch on J-Box PCB to the LEARN
MODE.
5. At the PCB in the Transceiver J-box, slide the Learn
Switch to LEARN (ON). See Figure 32.
6. On the Handheld Remote display screen, a prompt
will appear with instructions to slide the J-box
Learn Switch out of LEARN (OFF) and to press
the J-box Reset Switch (see Figure 32).
7. At the PCB in the Transceiver J-box, slide the
Learn Switch out of LEARN (ON) and press the
Reset Switch. The Red and Green LEDs on the
J-box will blink simultaneously (see Figure 21).
MAIN CONNECTOR
RESET
D2
D3
LEARN
Y B R G
OFF
ON
LEARN
OFF
ON
Red LED
(Send)
PCB
Green LED
(Receive)
Reset
Button
Learn
Switch
(Learn Mode ON)
Figure 33. Tranceiver J-box PCB Learn Switch
4.6 PDA Handheld Remote System
Defaults and General Modes
4.6.1
Basic Functions
The AquaLink PDA Handheld Remote can turn your
pool/spa equipment on and off in any of the following
three ways:
1. Activate the equipment manually through the
EQUIPMENT ON/OFF menu.
2. Program the equipment to turn on and off at
specific times. See Section 5.3 for a detailed
explanation of how to program equipment for
automatic operation.
3. Use the PDA handheld remote buttons 1 or
2 (Hotkeys). See Section 5.9 for a detailed
explanation of how to program Hotkeys 1 and 2.
NOTE The default setting for Hotkeys 1 and 2 are
AUX1 and AUX2 respectively. However, these
buttons can be assigned to any piece of
equipment connected to a circuit or relay.