ZENN
iO
AVANCE Y TECNOLOGÍA
vwww.zennio.com
37
37
Sending of "0" Delay:
specifies the time, in seconds, after which the value "0" will be
sent, once the corresponding signal has been received.
Sending of "1" Delay:
specifies the time, in seconds, after which the value "1" will be
sent, once the corresponding signal has been received.
Periodical sending of "0":
defines the period, in seconds, for a cyclical sending of the
value "0". Setting this to 0 disables the periodical sending.
Periodical sending of "1":
defines the period, in seconds, for a cyclical sending of the
value "1". Setting this to 0 disables the periodical sending.
Lock:
if "Yes" is chosen, a new 1-bit communication object, "[Ix] Lock", is deployed,
making it possible to lock and unlock the corresponding input (with one "1" or one "0",
respectively). During the time the input is locked, orders received from the KNX bus will be
ignored.
Sending statuses on bus voltage recovery:
this option allows forcing an automatic
sending to the KNX bus of the status of each input after a voltage recovery, with a certain
delay (value between 0 and 255, in seconds).
3.4.2. TEMPERATURE PROBE
When configuring an input as a temperature probe, the following options are available:
Figure 3.15. Input: Temperature probe
Temperature sensor calibration:
this is to re-calibrate (in tenths of a degree) the value
measured by the sensor when another sensor from the installation can be used as a
reference, thus making it possible to synchronize both measures.
