ZENN
iO
AVANCE Y TECNOLOGÍA
vwww.zennio.com
35
35
3.3.5. SCREENSAVER
The screensaver is a special page in ZAS that will be shown after a period of inactivity,
configurable by parameter.
It is possible to configure the screensaver to only show the current
Time
, the current
Temperature
(selecting the desired measurement source: Internal temperature sensor or a external value,
received by the "[General] Screensaver temperature" object) or
both
(alternatively every 5
seconds).
Note:
The temperature shown in the screensaver must be in the range [-20ºC, 95ºC].
The screensaver can also be
disabled
. In this case, after a period of inactivity greater than 45
seconds, ZAS will switch to Page 1 automatically. Moreover, the luminosity level of the Display can
be configured, being the possible options:
Always lighting:
the Display remains lit without switching off after the inactivity
period.
Automatic display attenuation:
the Display decreases its luminosity to level 3 after
the inactivity period.
On the other hand, parameter
“
Execute button action (Page 1) on screensaver exit?
” lets
determining whether, while the screensaver is active, one press on the touch panel (on any of the
single buttons or on the central binary button) should simply cause the screensaver interruption or,
moreover
–apart from exiting from the screensaver–, the execution of the action corresponding to
the pressed button, assuming it was pressed while Page 1 was active.
