ZENN
iO
AVANCE Y TECNOLOGÍA
vwww.zennio.com
31
31
It is possible to set a
header
, text string of up to 10 characters that identifies the Configuration page
and that will be shown in the left upper side of the display when accessing that page.
The adjustable parameters of ZAS are the following:
Contrast:
to adjust the contrast level of the ZAS display (value between 0 and 20). To
modify this level, just press the button corresponding to the Contrast in the touch panel (the
first one on the left). The current contrast level is then shown; to increase it, just press the up
arrow button and to decrease it, the down arrow button.
Light
to adjust the luminosity level of the ZAS display (value between 1 and 10). To
modify this level, just press the button corresponding to the Luminosity in the touch panel (the
first one on the right). The current luminosity level is then shown; to increase it, just press the
up arrow button and to decrease it, the down arrow button.
Time:
to set the clock time of the controller. Format is "hh:mm". To modify this, just press
the button corresponding to Time in the touch panel (the second one on the left). The current
time will be shown; the first thing to be modified is the hour, by means of the Arrow buttons.
Then, via the OK button or the Hour button itself, the focus goes to the Minutes, that can be
adjusted with the Arrow buttons. To confirm the new hour value, just press the OK button or
the Time button.
Note:
On bus power losses and depending on length, a delay in the internal time of the device
may happen. This must be kept in mind and corrected once the power supply is restored.
Calibration:
when pressing this button, ZAS goes into the calibration page. See the
calibration sequence in figure 1.3. A re-calibration may be necessary when the initial
calibration has not been carried out properly after downloading the application so presses
cannot be done in the centre of the button.
Programming LED:
when programming the physical address of the device, it is possible
to enter the programming mode directly by short-pressing this button. This feature avoids
having to access the rear side of the panel to physically push the “Programming Button”.
While the programming LED is active, the LED associated to this button will be ON. To leave
the programming mode, just short-press this button again (the programming LED and the
button LED will be switched off).
Reset:
a long press of at least of 3 seconds will be required on this button to reset ZAS.
All the stored statuses will be reset to the default values.
