Zeiss Axioskop 40, Руководство по эксплуатации, Страница: 49 / 146

Axioskop 40 START-UP
Axioskop 40 FL Attachments and conversions Carl Zeiss
B 40-810 e 12/01 2-19
2.2 Attachments and conversions
☞
This chapter only describes the steps required for attachments to and conversions of the
microscope. The corresponding components must be reset to a functioning status as described
in Chapters 2 and 3.
2.2.1 Changing the condenser
•
Move the stage carrier to the upper stop
position via the focusing drive.
•
Use lever (2-23/ 8 ) to fold out the front lens of
condensers with a swiveling front lens.
•
Move condenser carrier (2-23/ 2 ) to the lowest
position via height adjustment drive
(2-23/
5 ).
•
Undo both centering screws (2-23/ 3 ) until the
condenser can be easily taken out of its mount.
•
Lift the condenser from the orientation groove
by slightly tilting it upwards and pull it out to
the front.
•
Use lever (2-23/ 8 ) to fold out the front lens (if
available) on the condenser to be newly
inserted.
•
Insert condenser (2-23/ 1 ) between condenser carrier (2-23/ 2 ) and stage carrier (2-23/ 4 ). Orient the
locking screw on the bottom of the condenser in the direction of the groove (2-23/ 7 ).
•
Press the dovetail of condenser against the spring mount (2-23/ 6 ) of the condenser carrier until the
condenser can be placed on the condenser carrier horizontally.
•
Let the condenser go smoothly; the locking screw will lock in position in front of the groove (2-23/ 7 )
at the front.
•
Screw in centering screws until they engage in the dovetail.
Fig. 2-23 Changing the condenser