YOKOGAWA IR800G, Руководство пользователя

Страница: 98 / 127

IM 11G06A01-02EN
5-43
5. SCREENS
1st Edition : Oct. 27, 2023-00
l
Remote start
To perform automatic calibration, close (short-circuit) the input terminal to which "Auto Calibration
Start" is assigned in the contact input settings and open (open) it after at least 1.5 seconds. (For
contact input settings, see 5.2.4 Contact input setting)
Close (short circuit)
(Hold for 1.5 seconds or longer)
Open （ release ）
Automatic calibration start
Remote start input
Figure 5.13
CAUTION
• If a dialog box appears at the start of auto-calibration and auto-calibration cannot start, the
contact output and contact input settings are inadequate. See 5.2.3 Contact output setting
and 5.2.4 Contact input setting to assign the necessary functions
• An automatic calibration error occurs when a zero calibration error or span calibration
error occurs during the execution of automatic calibration. This auto-calibration error will
be resolved after the next successful auto-calibration or manual calibration (regardless of
success or failure).
• A calibration stability error may occur due to insufficient flow time when executing automatic
calibration. To clear the error, perform manual calibration or adjust the flow time and perform
automatic calibration again. (See 5.1.2 Auto Calibration Setting for more information on
flow time settings.
l
Cancel automatic calibration
Calibration can be forcibly discontinued during auto-calibration.
(1) Tap the on the measurement screen during auto-calibration, and
the confirmation dialog box for cancellation will be displayed. (If an
execution password has been set, you must enter the password before
the dialog appears. For passwords, see 5.3.1 Password).
(2) In the dialog box to confirm discontinuation, tap the [Yes] to stop the
calibration. The replacement time will begin, and the will blink.
(3) If you tap the blinking during the replacement time, you can also
stop the process during the replacement time.
Confirm cancellation dialog