10-9
IM 701510-01E
Outputting Displayed W
aveforms and
Setting Parameters to the Printer/Plotter
10
Explanation
Selecting the paper size
The contents of printing, paper size, printing size and printing location can be selected from
the following eight types. However, only one type of output can be selected at a time. “A5-
Upper WAVE” and “A5-Lower WAVE” allow output of two A5-sized screens of information
on a sheet of A4 paper.
Setting
Output item
Output size
Output location
A3-WAVE
Screen hardcopy
A3
Middle
A3-SETUP
Set-up parameters
A3
Middle
A4-WAVE
Screen hardcopy
A4
Middle
A4-SETUP
Set-up parameters
A4
Middle
A5-Upper WAVE
Screen hardcopy
A5
Upper half
A5-Lower WAVE
Screen hardcopy
A5
Lower half
A5-Upper WAVE &
Screen hardcopy
A5
Upper half
A5-Lower SETUP
Set-up parameters
A5
Lower half
A5-Upper WAVE &
Screen hardcopy
A5
Upper half
A5-Lower MEASURE
waveform measurement data
A5
Lower half
Selecting the pen speed
The pen speed can be selected from the following two speeds.
NORM
Plots at the default speed setting.
SLOW
Plots at a speed of 10 cm/s.
Selecting the pen assignment method: Pen Mode
The pens can be assigned according to the following two methods.
AUTO
Assigns pens automatically, as shown in the table below, according to the number
of pens.
Number of
GRID
TRACE
LOAD
installed pens
1
2
3
4
1
2
3
4
(MATH)
1
1
1
1
1
1
1
1
1
1
2
1
2
1
1
2
2
1
1
2
3
1
2
3
1
2
2
3
1
2
4
1
2
3
4
1
2
3
4
1
5
1
2
3
4
5
2
3
4
5
MANUAL
A particular pen can be assigned to the graticule, to TRACE1 to 4 (for DL1520/
DL1520L, 1/2/MATH) and to LOAD 1 to 4 (for DL1520/DL1520L, 1/2). The
pen numbers that can be assigned are 0 to 12. If “0” is selected, no plotting is
performed for the corresponding item.
Assignment of pens to the grid, trace and load
The grid, TRACE1 to TRACE4 and LOAD 1 to LOAD4 can have pens assigned to them as
follows.
Setting
Assignment for hardcopy
Grid
Graticule, all cursors, trigger position mark, date and time, comments, setup
information list, measurement values
TRACE1
Trace1 waveform, ground level, trigger level mark, voltage axis conditions,
input coupling, probe attenuation
TRACE2 to 4 Same as Trace1
(for DL1520/DL1520L, 2/MATH)
LOAD1 to 4
(for DL1520/DL1520L, 1/2)
Note
For DL1520 with suffix code -C1/-C3 or DL1520L with suffix code -C1/-C3/-C4, enable to print displayed
waveforms and additional information.
10.5
Printing Displayed Waveforms and Additional Information using an External Plotter
