12-6
IM 701510-01E
Loading ACQ waveform data
Note that only BIN data can be loaded.
11.
Press the “
LOAD
” soft key to display the loading menu.
12.
Use the rotary knob to select the file to be loaded.
13.
Press the “
EXEC
” soft key to start loading.
For DL1520L/DL1540L, if you have saved ACQ data to multiple
floppy disks, you can opt to load all of this data or only part of it (for
example, data from one disk only). If you do a partial load, the
waveform display will not appear over the entire time axis, but only
over a portion of it. If you want to display waveforms over the full
span of the time axis, insert the floppy disk(s) with the remaining ACQ
data and repeat Steps 11 to 13 as necessary (repeating the same
filename at Step 5).
Moving loaded ACQ waveforms
14.
The way to move these waveforms is exactly the same as for input
signal waveforms. For details, refer to page 5-7.
Canceling/holding the display of the loaded waveform
15.
Press the
INPUT key
of the channel corresponding to the number of
the loaded waveform. The acquisition hold menu appears.
16.
Press the “
ACQ Hold
” soft key to select “
OFF
”. Then when you
press the
START/STOP key
to start data acquisition, the loaded
ACQ waveform will be canceled. When you select “
ON
”, the loaded
ACQ waveform will not be canceled, even when you start data
acquisition. In this case, the channel display appears in the left upper
side of the screen.
17.
The way to display the ACQ waveforms and cancel them is exactly the
same as for input signal waveforms. For details, refer to page 5-1.
12.3
Saving and Loading Waveform Data
