9-9
IM 701510-01E
Performing a GO/NO-GO
Action
9
Setting the determination conditions
Parameter setup
5.
Press the “
Setup
” soft key of the GO/NO-GO top menu. The parameter menu will
appear.
6.
After having selected the “
Mode
” setting using the rotary knob, press the
SELECT
key
to select “
ON
”. Pressing the key once more results in selecting “
OFF
”.
7.
After having selected the “
Trace
” setting using the rotary knob, press the
SELECT
key
to select the trace used for measurement. Selectable from “
1
” to “
4
” (for DL1520/
DL1520L, 1/2/Math).
8.
After having selected the “
Item
” setting using the rotary knob, press the
SELECT key
to display the parameter setting screen.
9.
Use the rotary knob to select the parameter of measurement. Press the
SELECT key
,
the setting screen will disappear, and the setting will be shown at the “
Item
” setting.
10.
After having selected the “
Upper
” setting using the rotary knob, press the
SHIFT +
MISC (KEYBOARD key
to display the keyboard.
11.
Use the keyboard to enter the desired value. For details concerning operation of the
keyboard, refer to page 4-7.
12.
After having selected the “
Lower
” setting using the rotary knob, press the
SHIFT +
MISC (KEYBOARD key
to display the keyboard.
13.
Use the keyboard to enter the desired value. For details concerning operation of the
keyboard, refer to page 4-7.
14.
After having selected the “
Condition
” setting using the rotary knob, press the
SELECT key
to select the condition setting. When the condition is met, “NO-GO” will
result.
“OUT”
: The value of the measurement parameter lies outside the values determined
by the Upper and Lower values.
“IN”
: The value of the measurement parameter lies inside the values determined by
the Upper and Lower values.
15.
Repeat steps 6 to 14 until the parameter setup has been completed.
Determination Logic
16.
After having selected the “
Logic
” setting using the rotary knob, press the
SELECT
key
to select the desired condition. When the condition is met, “NO-GO” will result.
“AND” : All determinations are “NO-GO”;
“IN”
: Any of the determination is “NO-GO”.
Sequence determination
17.
After having selected the “
Sequence
” setting on using the rotary knob, press the
SELECT key
to select the desired sequence. The following types can be selected.
“SINGLE”
: Stops determination when a “NO-GO” determination is made;
“CONTINUE” : Carries out determination repeatedly until the “
ABORT
” soft key is
pressed.
9.2 Judging using Measured Values of Waveform Parameters
