Yamaha TS-S, Руководство пользователя

Страница: 134 / 286

5
o
peration
5-30
4.3 TEACH (Teaching)
When in the MANUAL mode ("MANUAL" ON) with "/LOCK" switched OFF, the current position can be written
to the specified point No. at the leading edge of the TEACH input ON.
n
NOTE
The TEACH function is disabled if a return-to-origin has not yet been completed.
Origin point
Position
Current position
210mm
Current position is written to the specified point No.
23533-M0-00
●
Writing the current position to a point for which data exists
No. RUN type Position [mm] Speed [%] Accel. [%] Decel. [%] Flag
P3 ABS 500 50 100 100 0
▼
TEACH
No. RUN type Position [mm] Speed [%] Accel. [%] Decel. [%] Flag
P3 ABS 210 50 100 100 0
The current position is written to the position data.
●
Writing the current position to a point for which data does not exist
No. RUN type Position [mm] Speed [%] Accel. [%] Decel. [%] Flag
P3 - - - - - -
▼
TEACH
No. RUN type Position [mm] Speed [%] Accel. [%] Decel. [%] Flag
P3 ABS 210 100 100 100 0
The current position is written to the position data, and default values are adopted for the other data.
n
Point No. setting conditions
An appropriate period of delay time must be provided between the point No. input and the current position TEACH
command so that this TEACH command is kept ON securely until the BUSY signal switches ON. If the point No. is not
set properly due to an insufficient delay time, this may cause a malfunction.
This delay time is set to 5 ms or longer.
c
CAutIoN
When the timer function of the host unit is used to specify the delay time, the design is made so that the actual
delay time is longer than the reference value shown above by carefully checking the timer response accuracy.