6S35H11
8-12
9
8
7
6
5
4
3
2
1
Ignition and ignition control system
Checking the crank position sensor
air gap
1.
Remove the flywheel magnet cover.
2.
Measure the crank position sensor air
gap
a
. Adjust if out of specification.
3.
Loosen the screws
1
and adjust the
crank position sensor air gap.
4.
Tighten the screws, and then check the
crank position sensor air gap.
Checking the engine temperature
sensor
1.
Remove the junction box cover.
2.
Disconnect the engine temperature sen-
sor coupler.
3.
Turn the engine start switch to ON.
a
6S380110
1
6S380120
Crank position sensor air gap:
0.5 – 1.5 mm (0.02 – 0.06 in)
4.
Measure the input voltage at the engine
temperature sensor coupler (engine tem-
perature sensor side). Check the wiring
harness if less than specification.
5.
Connect the digital circuit tester to the
engine temperature sensor coupler
a
and CDI unit coupler
b
(wiring harness
end).
6.
Check the continuity. Replace the wiring
harness if no continuity.
6S380126
DCV
Engine temperature sensor input
voltage: (reference)
Black/yellow (B/Y)
1
–
Black/yellow (B/Y)
2
5 V
6S380125
a
b
1
2
6S35H11_08 05.9.23 8:53 Page 13
Содержание 250GETO
