Yamaha 250GETO, Руководство по обслуживанию

Страница: 162 / 293

LOWR
6-25 6S35H11
Lower unit
Example:
If “T3” is 0.70 mm, then the pinion shim is
0.68 mm.
If “T3” is 0.74 mm, then the pinion shim is
0.72 mm.
Selecting the forward gear shim
1. Turn the thrust bearing 1 2 or 3 times to
seat the roller bearing outer race
2
, and
then measure the bearing height (M1) as
shown.
NOTE:
9
Select the shim thickness (T1) by using the
specified measurement(s) and the calcula-
tion formula.
9
Measure the thrust bearing to seat the roller
bearing at 4 points to find the height aver-
age.
9
Make of note the each measurement
numerical.
Digital caliper
3
: 90890-06704
5. Calculate the pinion shim thickness (T3)
as shown in the examples below.
NOTE:
“P” is the deviation of the lower case dimen-
sion from standard. The “P” mark
a
is
stamped on the trim tab mounting surface of
the lower case in 0.01 mm units. If the “P”
mark is unreadable, assume that “P” is zero
and check the backlash when the unit is
assembled.
Example:
If “M3” is 50.75 mm and “M4” is 30.57 mm
and “P” is (+ 2), then
T3 = 82.00 + (+ 2)/100 – 50.75 – 30.57 mm
= 82.00 + 0.02 – 50.75 – 30.57 mm
= 0.70 mm
6. Select the pinion shim(s) (T3) as follows.
Calculation formula:
Pinion shim thickness (T3) =
82.00 + P/100 – M3 – M4
Calculated numeral
Rounded numeral
at 1/100th place
1, 2 0
3, 4, 5 2
6, 7, 8 5
9, 10 8
Available shim thicknesses:
0.10, 0.12, 0.15, 0.18, 0.30, 0.40 and
0.50 mm
T1
6S360180
6S360185
M1
1
3
1
2
6S35H11_061 05.9.5 14:14 Page 28