wtw inoLab 740, Руководство по эксплуатации

Страница: 162 / 274

BOD
162
sample dilutions is acceptable. Reading in the identification
automatically causes the correct assignment of the start
measurement to the measured value.
In an end measurement without a barcode reader, follow the
prescribed order of the measurements.
12 Check the data on the display.
l If the data is correct: Continue with step 16.
l To change the data: Continue with step 13.
13 Swap between the selection fields with [Next] .
14 Select Yes or No in the Remove field with
82
.
l If Remove No was selected, the (default) values
from the start measurement are adopted.
l
If Remove Yes was selected, no end
measurement is performed for this blank value
solution. The value appears on the report marked
by *. This value is not used for calculating the BOD
value.
15 Immerse the sensor in the blank value solution.
16 Confirm the settings with [Start] .
l If Remove Yes was selected, a security prompt
appears before the removal. After confirmation
with
Yes , the next blank value solution is offered
for the end measurement (see step 12).
l
If Remove No was selected, the measurement of
the blank value solution begins.