VSpeak ECU Converter, Руководство пользователя

Страница: 27 / 38

ECU converter JetCat Version: 1.0 www.VSpeak-modell.de
Page 27/38
Mapping JetCat V10 – ECU Values
The JetCat V10 sensor occupies 14 slots, the assignment to the values of the JetCat ECU is as
follows:
Nr. JetCat V10 ECU value
1 RPM RPM (turbine)
2 Temperature EGT
3 Pump PUMP
4 Set RPM turbine set Solldrehzahl
5 Thrust -
6 Fuel FUEL (remaining fuel)
7 Fuel flow FuelFlow
8 Altitude -
9 Fuel quality THROTTLE
10 Battery BATT
11 Current ECU status as numerical current value
(s. Section 2.5.3)
12 Speed KMH
13 State Status / OFF-Condition
14 Second Shaft RPM2 (2nd shaft)
2.5.2 Turbinestatus – numerical "Current"-Values
The turbines status messages are displayed as numerical "Current" values. The assignment is
given in the following table:
Current
Description
0.0 A OFF
1.0 A Slow Down
2.0 A AutoOff
3.0 A WAIT for RPM (Stby/Start)
4.0 A PreHeat1 (only for direct Kerosene startup mode)
5.0 A PreHeat2 (only for direct Kerosene startup mode)
6.0 A Ignite
7.0 A Accleleration delay
8.0 A MainFStrt (only for direct Kerosene startup mode)
9.0 A Keros.FullOn (only for direct Kerosene startup mode)
10.0 A Accelerate
11.0 A Stabilise
12.0 A Learn LO
13.0 A Run (reg.)
14.0 A SpeedReg (Speed Ctrl)
15.0 A Two-Shaft-Regulate (only for turbines with secondary shaft)
100.0 A
all turbine shutdowns, except: - RC-Off
- Auto-Off
- Manual-Off
111.0 A like 100.0A, but only once for 2 seconds, e.g. for sum alarm
If in the transmitter an alarm thresold for the current of e.g. more than 105.0A is set, all turbine
shutdowns except for "RC-Off", "Auto-Off" and "Manual -Off" are signaled as a current alarm
for a period of 2 seconds.