ECU converter JetCat Version: 1.0
Page 19/38
2.3.4
Alarms / Parameterization
The change of sides takes place
with Enter and ESC button of the
SmartBox or with the appropriate
buttons on the HoTT transmitter.
The parameter is selected with
the INC- and DEC-buttons of the
SmartBox
(bzw. den Tasten der HoTT-
Sender) angewählt „
>
“.
If the alarm code is activated (inverse displayed), the alarm message assigned to
the respective letter is announced, which can be different for the 3 types of types
GAM / ESC and VAR.
Settings
Value range
Step size
Signal tone
OFF,10 . . . 2500 ml
10 ml
U
5.0 . . . 12.0 V
0.1 V
P
OFF,20.0 … 99.9
x 1000rpm
100 rpm
T
100 . . . 990 °C
10 °C
H
OFF,1.0 … 99.9
x 1000rpm
100 rpm
T
OFF,10 . . . 150 kmh
1 kmh
A
Upon delivery, the warning thresholds are set as shown in the picture.
As can be seen in the table, the alarms for FUEL, RPM, RPM2, LoSpeed and HiSpeed can be
switched OFF, if no alarm is to be given at BATT and EGT, the alarm thresholds can be set to
"inaccessible" values.
Permanently pending alarms, e.g. FUEL or BATT, max. 3 times repeated.
FUEL
The alarm Fuel is signaled when the remaining fuel is lower than the FUEL set value.
With or the value of the
selected parameter is enabled for change
(inverted).
With the value can be increased,
With it can be reduced.
Stored is after or
INC+DEC
SET
INC
DEC
SET
INC+DEC
ESC
ENTER
These two keys can be
used to switch between
the parameter value and
the respective alarm
character.
DEC
INC
ESC
ENTER