ECU converter JetCat Version: 1.0
Page 32/38
2.6.2
S.Port ID
On delivery, the ID of the VSpeak ECU converter is set to 28.
A change can be made via the settings of the ECU converter (see chapter 2.6.3) or with the
FrSky DASHBOARD.
This is useful if another sensor with the same ID is already connected to the S.Port bus, or a
model is equipped with several turbines.
For this purpose, the Telemetry port of the VSpeak ECU converter must be connected with a
V cable and a receiver battery to the FrSky DASHBOARD. Furthermore, the ECU converter
must be connected to the powered JetCat ECU or with the Programming adapter
2.6.3
Setup
For the FrSKY system a variety of settings in VSpeak ECU converter using the Programming
a JetCat GSU can be made.
In the overview the complete menu structure for all possible range of settings is shown.
The navigation takes place in the usual way, ie "scroll" between the parameters with the +/-
buttons - Value change with the pushed "Change Value / Item" button and added +/- buttons,
then instead of the ":" a small arrow shows the changed values.
1 . . . 28
Set: 28
(s. section 2.6.2)
1 . . . 16
Set: 1
(s. section 2.6.2)
Turbine / 2Shaft
Set: Turbine
OFF / kts / kmh
Set: kts
The parameter "Sensor Airspeed" is used to set how the speed value is to be transmitted via
S.Port telemetry. The value supplied by the JetCat ECU in kmh must be transmitted as kts so
that the speed value is displayed correctly in kmh in the taranis. The speed transmission can be
deactivated with the VSpeak ECU converter - e.g. if a FrSKY speed sensor has been installed
in the model.
Physica l ID
: 28
Group Number
: 1
Sensor A i rspeed
: transm i t as kts
Sensor RPM
: Turb i ne
Te l emetry System
: FrSKY