VSpeak ECU Converter, Руководство пользователя

Страница: 31 / 38

ECU converter JetCat Version: 1.0 www.VSpeak-modell.de
Page 31/38
2.6.1 Turbinestatus / OFF-Condition – numerial „Temperature“-Values
The turbines status messages are also displayed numerical values. The assignment is given in
the following table.
Tmp2 Description
0 OFF
1 Slow Down
2 AutoOff
3 WAIT for RPM (Stby/Start)
4 PreHeat1 (only for direct Kerosene startup mode)
5 PreHeat2 (only for direct Kerosene startup mode)
6 Ignite
7 Accleleration delay
8 MainFStrt (only for direct Kerosene startup mode)
9 Keros.FullOn (only for direct Kerosene startup mode)
10 Accelerate
11 Stabilise
12 Learn LO
13 Run (reg.)
14 SpeedReg (Speed Ctrl)
15 Two-Shaft-Regulate (only for turbines with secondary shaft)
-1 Shut down via RC
-2 Auto Off
-3 Manual Off (via GSU)
-4 Acceleration time out
-5 Acceleration too slow
-6 Over RPM
-7 Low Rpm Off
-8 Low Battery
-9 Overtemperature
-10 Low temperature Off
-11 Hi Temp Off
-12 Glow Plug defective
-13 Watch Dog Timer
-14 Fail Safe Off
-15 Ignition timeout
-16 Power fail (Battery fail)
-17 Temp Sensor fail (only during startup)
-18 Fuel fail
-19 Prop fail (only two shaft engines)
-20 2nd engine fail
-21 2nd engine differential to high
-22 2nd engine no communication
-23 No oil (only on engines with separate oil reservoir)
-24 Over current
-25 No fuel pump connected/found
-26 Wrong fuelpump connected
-27 Fuelpump communication error
-28 Out of fuel shut down (only on engines with fuel sensor, like RXi types)
-29 Low Rpm shutdown, possibly due to Pump failure
-30 Low Rpm shutdown, possibly due to frontboard failure
-31 Clutch fail (starter motor clutch is not decoupling)
-32 ECU reboot due to re-matching of new engine connected
-40 (-
4
…-32) once for 2 seconds, e.g. for sum alarm