ECU converter JetCat Version: 1.0
Page 17/38
2.3.3
Data-Display/Speech
2.3.3.1
GAM - General Air Modul
"EIN" indicates that the turbine is in the "RUN (reg.)", "SpeedCtrl" or "Rpm2Ctrl" status.
Since the GAM can only display temperatures up to 235°C, the temperature is divided by 10.
If you see a value of 48°C on the display, you have a "real" temperature of 480 - 489°C.
The fuel level is shown as gauge in % and as numbers in ml. The 100% value is set at startup.
The value in ml transferred during the powerup of the ECU is used as 100% value for
calculation.
The current is also displayed from JetCat ECU V10.
If an AIRSPEED sensor is connected to the ECU, the speed is displayed in kmh.
The RPM display can be set with the "RPM-sel" parameter between the turbine RPM and RPM2
for 2-shaft turbines..
When the Vario tone is switched on, all switch-off conditions (except "RC-Off", "Auto-Off"
and "Manual Off") are signaled as "strong rise" (+ 300.00m / s) for 2 seconds.
2.3.3.2
ESC - Electronic Speed Control
The ESC temperature display is limited to 235 ° C, so the turbine jet temperature is shown
divided by 10, or the other way around: 48 ° C in the display corresponds to 480 ... 489 °C.
The RPM display can be set with the "RPM-sel" parameter between the turbine RPM and RPM2
for 2-shaft turbines.
Run (reg.)
FUEL
BATT
EGT
PUMP
RPM / [RPM2]
EGT (max)
FUEL in %
EGT (max)
BATT
FUEL in %
EGT
FUEL
RPM (max)
[RPM2 (max)]
RPM
[RPM2]
PUMP
