VIPA System 200V IM Series, Руководство пользователя

Страница: 321 / 348

Manual VIPA System 200V
Chapter 8 Ethernet coupler
HB97E - IM - Rev. 06/29 8-17
This area shows all information about the Ethernet coupler like symbolic
name, version and status monitors of the LEDs.
Symbolic name
: Via WinNCS you may assign a symbolic name to the
Ethernet coupler besides the IP address.
HWVer
: This is the hardware version (electronics). The HW release (only
number before comma) is also at the front side of the module.
PLDVer
: The PLD (
P
rogrammable
L
ogic
D
evice) is a programmable logic
block for control of the communication between backplane bus and
processor.
FWMajor, FWMinor
: The firmware version is divided into
FWMajor
(main
version) and
FWMinor
(lower version). A lower version contains small
alterations. When basic alterations are made, the main version number is
increased.
RDY, ERR
: Status monitor of the LEDs RD and ER
rdy (small letter): LED is blinking / RDY (capital letter): LED is on
As long as the Ethernet coupler communicates error free, the status
monitor remains like shown above. In case of an error, e.g. the following
message is displayed below ERR:
QVZ=0 Ready=1, Run=0, Bus_Err=1, Init_Err=0, Prm_Err=0, Alarm=0
old_number_modules=4, new_number_modules=3
This message shows that one module is defect.
This area shows all information about the in-/output periphery like module
name, in-/output assignment, if existing parameter bytes and diagnosis
data.
Module name
: The order number of the module serves as module name.
This allows an unambiguous identification of the module.
In-/output assignment
: Here you find four informations:
•
Type: input area (IB), output area (QB)
•
The start address of the area is in brackets
•
You see the number of bytes occupied by the module
•
The content of the bytes corresponds to that of the Ethernet coupler at
the last website update
Example:
Slot 4
IB[6]=
00 00 00 00
00 00 00 00
The
Prm()=
Parameter bytes contain the following information:
•
The length of the parameter block is in brackets with a preceding
len
.
•
The content of the bytes are the parameter bytes of the according
module.
DIAG
= showes 16Byte diagnosis data for the alarm handling.
Diagnosis
Ethernet coupler
Status monitor
Module area
Slot 0 ... 31
VIPA 253-1NE00
Station A
HWVer: 10
PLDVer: 10
FWMajor: 1
FWMinor: 3
RDY
ERR
VIPA 253-1NE00
Station A
HWVer: 10
PLDVer: 10
FWMajor: 1
FWMinor: 3
RDY
ERR
QVZ=0, Ready=1, Run=0,
Bus_Err=1, Init_Err=0,
Prm_Err=0, Alarm=0,
old_number_modules=4
new_number_modules=3
Slot 4
231-1BD52
IB[6]=
00 27 af 00
00 00 2d 04
Diag=
0d 15 00 00
74 08 04 04
00 00 01 00
00 00 00 00
DiagAlarm
Prm(len10)=
00 00 2d 2d
28 28 00 00
00 00
here:
DiagAlarm occured