VIPA System 200V IM Series, Руководство пользователя

Страница: 24 / 348

Chapter 2 Assembly and installation guidelines
Manual VIPA System 200V
2-6 HB97E - IM - Rev. 06/29
The following sequence represents the assembly procedure as viewed
from the side.
•
Install the profile rail. Make sure that a clearance of at least 60mm exists
above and 80mm below the middle of the bus rail.
•
Press the bus connector into the rail until it clips securely into place and
the bus-connectors protrude from the profile rail. This provides the basis
for the installation of your modules.
•
Start at the outer left location with the installation of your header module
like CPU, PC or bus coupler and install the peripheral modules to the
right of this.
1 2
4
3
•
Insert the module that you are installing into the profile rail at an angle of
45 degrees from the top and rotate the module into place until it clicks
into the profile rail with an audible click. The proper connection to the
backplane bus can only be guaranteed when the module has properly
clicked into place.
Attention!
Power must be turned off before modules are
installed or removed!
Assembly
procedure
➡➡
➡
➡
Clack
[1] Header module
like PC, CPU, bus
coupler
[2] Header module
when this is a
double width or a
peripheral module
[3] Peripheral module
[4] Guide rails